Wifi/Smart Home Compatible
FOR SMART HOME OR AUTOMATIC TIMER USE, THIS FEATURE MUST BE ENABLED ON THE BLANKET CONTROLLER.
To activate this feature:
- 1. Turn the controller off.
- 2. While off, press and hold the “PREHEAT” key for approximately 2 seconds until the display blinks “AO” for 20 setting controllers, or the preheat LED blinks once for 5 setting controllers.
- 3. Release the “PREHEAT” button and allow the display or LED to turn off.
- 4. The controller should now be in automatic mode.
- 5. To test, turn controller on and allow the display/LED to dim. Do NOT turn the controller off using the power switch. Disconnect the powercord from wall outlet, wait 5 seconds, then plug the power cord back in the wall outlet. The controller should power on, perform a powerup test, then remain operating at the last setting used during previous operation.
To disable this feature:
- 1. Turn the controller off.
- 2. While off, press and hold the “PREHEAT” key for approximately 2 seconds until the display blinks “OF” for a 20 setting controller, or the preheat LED blinks twice for a 5 setting controller.
- 3. Release the “Preheat” button and allow the display or LED to turn off.
- 4. The controller should now be in normal operation mode.
- 5. To test, turn controller on and allow the display/LED to dim. Do NOT turn the controller off using the power switch. Disconnect the powercord from wall outlet, wait 5 seconds, then plug the power cord back in the wall outlet. The controller should only perform a power up test, then shut off.